Ensure the substrate is clean and free from dust, oil, grease and loose particles before application. Dampening of substrate is required before applying Tile Adhesive. Checking the Verticality/ plumb level of substrate is essential. Ensure that new concrete substrate/Masonry wallis at least four weeks old and screeds/cement sand base coats are minimum 14 days old before applying such Adhesives.

Approx. 24% water (by weight of material) is required for mixing. Mixing can be done either manually or with mechanical mixer / stirrer. It is advisable to use a mechanical mixer to get homogeneous mix. The material should be applied within 90 minutes after preparation. It is recommended to apply Tile Adhesive with a Notched Trowel that can provide minimum 3mm thick layer. It is recommended to have thickness

between 3-9 mm. Grouting Activity can be taken after 24 hours and designed/full Traffic be allowed after 48 hours of installation.

No curing is required. Natural air curing is enough.

Elite Dry Mix Solutions – Floor & Wall Tile Adhesive is delivered in a 20 Kg bag. Storage life is Twelve months ifthe products stored in a dry place.

Recommended to wear NIOSH approved or equivalent particulate face mask when mixing the material. Material contains cement, which may produce an allergic effect. Keep out of reach of children. Material may cause irritation to eyes and skin. In case of contact with eyes, rinse immediately with plenty of water and seek medical assistance. After contact with skin, wash immediately with plenty of soap and water. Avoid contact with eyes and prolonged contact with skin.

It Is assumed that all standard Civil Engineering Practices shall be adopted for application of the Tile Adhesive. The information given in this leaflet

is for general guidance only.